QUICK SET-UP  (RBA4)

This only works on a empty memory.
If you have already run a setup you need to delete the memory. (Go to Delete Memory).

If you have deleted the memory and need to run quickset again.

1. Move the gate to the halfway position of its path

2. Lock the gearmotor

3. Power the control unit through the mains and wait 10 seconds

4. Press and release the Open button

5. Let the gate performs the closing, opening and closing manoeuvres on it's own.
Delete the Setup Memory (RBA4)
from previous setups otherwise it won't remember the new setup.

1. Press and hold buttons Open and Close simultaneously for 3 seconds.

2. LEDs L1, L2 and L3 will start flashing at the end of the procedure.

3. Now start the QUICK SET-UP procedure

This procedure does not cancel the transmitters memory.

Increasing the Motor Force
for heavier and larger Gates.

1. Press and hold Set for roughly 3 sec.

2. Release the Set button when LED L1 starts flashing

3. Press and use the Open and Close buttons to move the flashing light to L1. 

4. While holding down the Set Button use another finger and move the open and close buttons to move to the next level in this case move to L3 for more force to push the gate.

5. Release the set button and your done. 

CB Model RBA4
CB Model RBA4
CB Model RBA4
CB Model RBA4/A
Delete the Setup Memory (RBA4/A)
from previous setups otherwise it won't remember the new setup.

1. Press and hold buttons PP and Radio buttons simultaneously for 3 seconds.

2. LEDs L2 and L3 will start flashing at the end of the procedure.

3. Now start the QUICK SET-UP procedure

This procedure does not cancel the transmitters memory.

QUICK SET-UP for the RBA4/A

1. Move the gate to the halfway position of its path

2. Lock the gearmotor

3. Power the control unit through the mains and wait 10 seconds

4. Hold down the Stop/Set and the PP Buttons at the same time for 3 sec.

5. Let the gate performs the closing, opening and closing manoeuvres on it's own.

Always remember to allow 10 seconds between instruction
Increasing the Motor Force
for heavier and larger Gates.

1. Press and hold Set for roughly 3 sec.

2. Release the Set button when LED L1 starts flashing

3. Press and use the Open and Close buttons to move the flashing light to L1.

4. While holding down the Set Button use another finger and move the open and close buttons to move to the next level in this case move to L3 for more force to push the gate.

5. Release the set button and your done. 

CB Model RBA4/A
CB Model RBA4/A
CB Model RBA4
swing gate electric lock
Swing Gate Electric
Lock
Control Board for Swing and Sliding gate Motors
Control
Boards
For
Gate Motors
Sliding gate motor
Sliding
Gate
Motor
  Related Products
Hand
Remotes
Remotes for gates
 
Delivering
Around Australia Daily
Delivering
Australia-wide
and WorldWide