1300 121 666
Design - Fabrication - Installation - Repair - Service - Sales - Maintenance - Spare Parts
Single Gate Frame: Enquiry Form (Part-1)
Measure both top and Bottom of the opening.

The Shortest Measure is what you need
The Measurements you need to know and supply
Step One.
Width
Step Two.
Height
Normally the Clearance at the bottom of the gate is between 50 and 70mm
Deduct this from your Height
Step Three.
Now you should have your measurements for your new Frame

1. The Shortest measurement for the Width
2. The Height minus the clearance


We can make the frame out of square you need to add a extra $20 for this
Width
Hight minus the cleance at the bottom
Enter Millimeters Only
Enter Millimeters Only
Your cost based on the Measurements Supplied
Hight minus the cleance at the bottom
 
Top measurment
Bottom measurment
Copyright © 2008 by Gatesplus  -  All Rights reserved  - Site  Maintenance and Design by Gatesplus

Factory 3/9 Sherwood Crt, Wantirna, Victoria 3152.  ABN 96 205 178 715 - Telephone 1300 121 666  -  Fax: 03 8640 0791  -   E-Mail: sales@gatesplus.com.au
REGISTERED BLUESCOPE STEEL MEMBER  BlueScope is a trademark of BlueScope Steel Limited COLORBOND® is a brand name (Trade Mark) of Bluescope Steel Limited